![]() This shell characters using laser engraving.It also allows you to program your target board with both 5V and 3.3V. This device offers 5V and 3.3V st the same time. ![]() Its interface definition directly marked on the shell, clear, convenient, and practical.There is PCB installed inside of aluminum alloy U disk shell, portable, safe, and reliable.The connector on the opposite side of this device is a USB connector and is intended to be plugged into the computer. The header for this ST-Link v2 programmer contains connections for 5V, 3.3V, SWCLK, SWDIO, SWIM, Reset (RST/NRST) and GND. Use this device to send program code to the 32-bit STM32 ARM Cortex or 8-bit STM8 icrocontrollers. ST Link V2 Programmer For STM8 and STM32 is fully consistent with the official version, support for automatic upgrades, support the full range STM32 SWD (only 4pins including SWCLK, SWDIO, and power) and a full range STM8 SWIM (only 4pins including SWIM, Reset and power) download and debug. You can even get 5V and regulated 3.3V power! Since STM’s are so common, this tool will come in handy whenever you encounter them. ST Link V2 Programmer is little USB stick contains a microcontroller with the code for ST’s classic programmer/emulator for STM8 and STM32 bit processors. ST Link V2 Programmer Compatible Programmer & Emulator / Debugging dongle. ST Link V2 Programmer is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families.
0 Comments
Leave a Reply. |